Mitsubishi; Extension With Additional Inputs/Outputs - Festo EduTrainer Manual

2 Assembly instructions

2.1.4 Mitsubishi

– Assembly:
The controller is assembled by engaging it on the H-rail (DIN EN 50022).
– Disassembly:
The controller is disassembled by lifting the quick fastener using a screwdriver and removing the
controller from the rail.
Note
Further information on assembling or disassembling the controller or individual extension modules can
be found in the manuals of the respective controller manufacturers.

2.2 Extension with additional inputs/outputs

The installation process is shown using a Siemens controller as an example. This process is essentially the
same for all controllers; the only difference is how the controller is mounted on the holder system.
1. Remove as many blanking plates as necessary.
2. Guide the flat cable of the new I/O module through the opening in the housing and assemble the
module.
3. Connect the flat cables with the chosen 19-inch module.
4. To do this, connect the new 19-inch module with the last 19-inch module connected (e.g. SysLink
system connector module) via the 3-pin 24 V power supply cable.
46
© Festo Didactic GmbH & Co. KG 739319