Siemens - Festo EduTrainer Manual

2.1.3 Siemens

– Assembly:
1. Start by mounting the power supply. Move this to the left as far as the earthing screw of the
mounting rail and screw it in tightly.
2. Establish a connection with the other modules by inserting a bus connector into the CPU (see
picture detail).
3. Mount the CPU (1).
4. Push the CPU over as far as the left-hand module (2).
5. Now tilt it downwards (not before) (3).
6. Hand-tighten the modules onto the mounting rail.
7. If you are using a CPU with MMC, insert this into the module slot.
8. You must assemble one digital input module and one digital output module on the right beside the
CPU. To do this, repeat steps 1 to 6.
Note
Further information on assembling or disassembling the controller or individual extension modules can
be found in the manuals of the respective controller manufacturers.
© Festo Didactic GmbH & Co. KG 739319
2 Assembly instructions
45