Commissioning; Technical Data; Contact Allocation Table - Festo EduTrainer Manual

8 19-inch module 4AIN/2AOUT

8.2 Commissioning

1. Connect the inputs/outputs to the PLC using a flat cable:
– SV3/SV4: Siemens S7 analogue additional module with 20-pin plug (2 x 16-pin)
– SV2/SV5: Siemens S7 integrated analogue module with 40-pin plug (2 x 16-pin)
– SV1/SV6: Other controller types (16-pin)
2. If using modules in parallel, these can be connected via the free insulation-displacement connector SV1
or SV6 using flat cables.
3. Connect the 24 V power supply by means of the 3-pin connector SL1 or SL2.
4. Use the jumper JP2 to define whether the output module is supplied directly via 24 V or via 24 V NA.
24 V NA is switched off in the event of an EMERGENCY-STOP.
5. Screw the 19-inch module into the frame.

8.3 Technical data

Operating voltage
Input/output voltage
Connection
Front-plate width
Subject to change

8.4 Contact allocation table

Pin SV1
1 UA1
2 IA2
3 UA2
4 IA1
5 0V
6 —
7 IE2
8 IE4
9 IE1
10 IE3
11 0V
12 UE4
13 UE2
14 UE3
15 UE1
16 —
60
SV2 SV3 SV4
0V IE3 0V
IE3 0V IA2
0V IE3 0V
UE3 UE3 0V
0V IE3 0V
0V IE2 UA2
0V IE3 0V
IE2 0V IA1
L1 L1 UE4
UE2 UE2 0V
L1 L1 UE4
0V IE1 UA1
L1 L1 UE4
IE1 0V IE4
L1 L1 UE4
UE1 UE1 0V
24 V DC
0 ... 10 V DC and ± 10 V DC respectively
4 mm safety sockets
12 modules
SV5 SV6
0V UA1
IA2 IA2
0V UA2
UA2 IA1
0V 0V
IA1 —
0V IE2
UA1 IE4
UE4 IE1
— IE3
UE4 0V
— UE4
UE4 UE2
0V UE3
UE4 UE1
IE4 —
© Festo Didactic GmbH & Co. KG 739319