Festo EduTrainer Manual page 48

2 Assembly instructions
Converting the rack variant to an A4 variant
The respective conversion kit can be ordered from Festo Didactic.
1. Screw in and tighten the rubber buffers and washers by hand.
2. Loosen the aluminium rails using an Allen key and remove.
3. Loosen the screws on the housing back wall using an Allen key, shift the housing back wall downwards
to the stop, and retighten the screws on the housing back wall.
If you want to place the A4 variant at an angle on the table, you must assemble the handle in the position
shown below.
48
© Festo Didactic GmbH & Co. KG 739319