Lan Configuration; Example Program Syslogd Start With The Parameter -R; Configuration Of Network Interface - Advantech ER75s User Manual

Example of logging into the remote daemon at 192.168.2.115:
Figure 23: Example program syslogd start with the parameter -r
8.8 LAN configuration
To enter the network configuration, select the LAN menu item.
Item Description
IP address Fixed set IP address of network interface ETH.
Subnet Mask IP address of Subnet Mask.
Media type
Default Gateway IP address of router default gateway. When entering IP address of
default gateway, all packets for which the record was not found in the
routing table, sent to this address.
DNS server IP address of DNS server of router. Address where they are forwarded
to all DNS questions on the router.
Default Gateway and DNS Server items are used only if LAN is selected by Backup routes
system as a default route (selection algorithm is described in section
DHCP server assigns IP address, gateway IP address (IP address of the router) and IP
address of the DNS server (IP address of the router) to the connected clients. If these values
Auto-negation – The router selects the speed of communication
of network options.
100 Mbps Full Duplex – The router communicates at 100Mbps,
in the full duplex mode.
100 Mbps Half Duplex – The router communicates at 100Mbps,
in the half duplex mode.
10 Mbps Full Duplex – The router communicates at 10Mbps,
in the full duplex mode.
10 Mbps Half Duplex – The router communicates at 10Mbps,
in the half duplex mode.
Table 19: Configuration of network interface
30
ER75s
8.11 Backup Routes).