Table of Contents
Advertisement
While filling of sign "*" it is possible control the router with the help of an SMS sent from every
numbers.
Control SMS message doesn't change the router configuration. If the router is switched
to offline mode by the SMS message the router will be in this mode up to next restart. This
behavior is the same for all control SMS messages.
It is possible to send controls SMS in the form:
SMS
go online sim 1
go online sim 2
go online
go offline
set profile std
set profile alt1
set profile alt2
set profile alt3
reboot
get ip
By choosing Enable AT-SMS protocol on TCP port and enter the TCP port it is possible to
send/receive an SMS on the TCP port. SMS messages are sent by the help of a standard AT
commands.
Item
Description
TCP Port
TCP port on which will be allowed to send/receive SMS messages.
Table 55: Send SMS on ethernet PORT1 configuration
8.22.1 Send SMS
After establishing connection with the router via serial interface or Ethernet, it is possible
to use AT commands for work with SMS messages.
The following table only lists the commands that are supported by Advantech B+B Smart-
Worx routers. For other AT commands is always sent OK response. There is no support for
treatment of complex AT commands, so in such a case router sends ERROR response.
AT Command
Description
AT+CGMI
Returns the manufacturer specific identity
Description
Switch to SIM1 card
Switch to SIM2 card
Switch router in online mode
connection termination
Set standard profile
Set alternative profile 1
Set alternative profile 2
Set alternative profile 3
Router reboot
Router send answer with IP address SIM card
Table 54: Control SMS
80
ER75s
Continued on next page
Advertisement
Table of Contents
