IBM Storwize V7000 Unified Series Problem Determination Manual page 204

Hide thumbs Also See for Storwize V7000 Unified Series:
Table of Contents

Advertisement

Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
Parameters
-file
-ignore
Description
This command copies the file from the USB key to the upgrade directory on the
node canister.
This command calls the satask installsoftware command.
Create cluster command:
Use this command to create a storage system.
Note: The reference to cluster is not the same as the file system cluster on the
Storwize V7000 file modules.
Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
Parameters
-clusterip
-gw
-mask
-clusterip_6
180
Storwize V7000 Unified: Problem Determination Guide Version
satask
installsoftware
(Required) The file name of software installation package.
(Optional) Overrides prerequisite checking and forces installation of the
software.
satask
mkcluster
-clusterip
satask
mkcluster
-clusterip_6
(Optional) The IPv4 address for Ethernet port 1 on the system.
(Optional) The IPv4 gateway for Ethernet port 1 on the system.
(Optional) The IPv4 subnet for Ethernet port 1 on the system.
(Optional) The IPv6 address for Ethernet port 1 on the system.
-file
filename
ipv4
-gw
ipv4
-mask
ipv6
-gw_6
ipv6
-prefix_6
-ignore
ipv4
-name
cluster_name
int
-name
cluster_name

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents