Sas Riser-Card And Controller Assembly On The 16-Drive-Capable Server Model; Installing The Sas Riser Card And Controller Assembly - IBM Storwize V7000 Unified Series Problem Determination Manual

Installing the SAS riser card and controller assembly

The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 51.
To install the SAS riser-card and controller assembly in the file module, complete
the following procedure.
1. To help you work safely with Storwize V7000 Unified file modules, read the
2. To install the SAS riser-card and controller assembly for a 16-drive-capable
SAS controller
SAS riser card
SAS controller
front retention
bracket
Figure 21. SAS riser-card and controller assembly on the 16–drive-capable server model
b. Lift the front and back edges of the assembly to remove the assembly from
the server.
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 54.
server model, complete the following steps.
Figure 21 shows the SAS riser-card and controller assembly in the
16-drive-capable server model.
Alignment post
a. If you are replacing a ServeRAID-BR10il v2 SAS/SATA controller with a
ServeRAID-M5015/M5014 SAS/SATA controller, you must swap the
controller retention brackets to fit the new SAS controller. See Figure 22 on
page 114.
113
Chapter 4. File module