Va Safety Cover; Setting The Machine Type, Model, And Serial Number - IBM Storwize V7000 Unified Series Problem Determination Manual

Screw
Safety cover
Alignment
tabs
Figure 45. 240 VA safety cover
2. Slide the safety cover toward the back of the server until it is secure.
3. Connect the hard disk drive backplane power cables to the connector in front
4. Install the screw into the safety cover.
5. Install the SAS riser-card assembly.
6. Install the server cover.
7. Slide the server into the rack.
8. Reconnect the external cables, then reconnect the power cords and turn on the

Setting the machine type, model, and serial number

The following procedure is for a field replaceable unit (FRU). FRUs must be
installed only by trained service technicians.
The ASU package is part of the Storwize V7000 Unified code. ASU is available to
authorized service personnel from the command-line interface (CLI) on the file
module. Use ASU to modify selected settings in the integrated-management-
module (IMM)-based Storwize V7000 Unified file modules.
You can use the ASU remotely from your laptop (if allowed) or from a file module
that has Storwize V7000 Unified installed.
1. Access and log in to the Storwize V7000 Unified system from the CLI.
2. Issue the following command to view the current settings for the machine type
3. Issue the ASU command on the Storwize V7000 Unified file module to set the
4. Issue the following command to verify that you set the machine type and
of the safety cover.
peripheral devices and the server.
and model:
asu show SYSTEM_PROD_DATA.SysInfoProdName
machine type and model:
asu set SYSTEM_PROD_DATA.SysInfoProdName 2073-700
model number correctly:
asu show SYSTEM_PROD_DATA.SysInfoProdName
155
Chapter 4. File module