Rear; Figure 11 Rear View Of A Controller Enclosure (Eternus Af150 S3/Af250 S3) - Fujitsu ETERNUS AF S3 Series Basic Operation Manual

All-flash arrays
Hide thumbs Also See for ETERNUS AF S3 Series:
Table of Contents

Advertisement

A. Component Names
Controller Enclosure

Rear

This section provides the names of the components in the rear of a controller enclosure.
ETERNUS AF150 S3/AF250 S3
Figure 11
Rear View of a Controller Enclosure (ETERNUS AF150 S3/AF250 S3)
1
2
3
CM#0
CA#0
PSU#0
1
Controller (CM#0, CM#1) (refer to
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3
Host interfaces (CA#0, CA#1) (refer to
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5
RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7
Power supply units (PSU#0, PSU#1) (refer to
1
4 5
3
6
CA#1
7
"■ Controllers" (page
"■ Host Interface" (page
2
3
4
5
3
CA#0
CA#1
PSU#1
7
73))
79))
"■ Power Supply Units" (page
69
6
CM#1
77))
Operation Guide (Basic)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus af150 s3Eternus af250 s3, eternus af650 s3

Table of Contents