Operation - Pace ST 115 Operation & Maintenance Manual

Operation

Password
4. The LED Display will display the version of the microprocessor and
change to read "P--" or "EP0".
5. If the display reads "EP0", a Password has
been stored in system memory. Enter the 5 key
sequence Password. If the Password entered
is incorrect, "no" appears on the display and
the system then returns to normal operation. If
this occurs, repeat steps 1 through 5 and enter
the correct Password.
6. The LED Display reads "P- -". Choose one
of the following options:
a) Press the Program Key
keep the currently stored Password
(including no Password).
b) Press and release the Scroll Up (▲) Key to enter a new Password.
c) Press and release the Scroll Down (▼) Key if you wish to remove a
stored password or do not wish to store a Password.
7. If the LED Display now reads "EP0", select and enter a 5 key password
sequence. Make a note of the entered Password. As the Password is
entered, the last digit of the display will count up with each key entry.
After the fifth key entry, proceed to step 8.
Temperature Scale
8. The LED Display now shows the stored
default Temperature Scale (°C or °F
temperature shown on LED Display). Choose
one of the following:
a) Press the Program Key t o
the stored default Temperature Scale.
b) Press and release the Scroll Up (▲) Key to
change the default Temperature Scale.
Press and release the Program Key.
Set-Up Mode
to
keep
27