Local Control Panel And Programming; Local Control Panel (Lcp); Introduction - Danfoss VLT AutomationDrive FC 360 Quick Manual

Local Control Panel and Pro...

5 Local Control Panel and Programming

5.1 Local Control Panel (LCP)

5.1.1 Introduction

FC 360 supports numerical local control panel (LCP 21),
graphic local control panel (LCP 102), and blind cover. This
chapter describes the operations with LCP 21 and LCP 102,
as well as how to program with LCP 21. For details about
how to program with LCP 102, see the Programming Guide.
NOTICE
The frequency converter can also be programmed from
the MCT-10 Set-up software on PC via RS-485 com-port.
This software can be ordered using code number
130B1000 or downloaded from the Danfoss website:
www.danfoss.com/BusinessAreas/DrivesSolutions/software-
download
5.1.2 Numerical Local Control Panel LCP 21
The Numerical Local Control Panel (LCP 21) is divided into
4 functional sections.
A. Numeric display
B. Menu key
C. Navigation keys and indicator lights (LEDs)
D. Operation keys and indicator lights (LEDs)
1
A
Setup 1
2
Status
4
B
Menu
9
C
On
OK
6
Warn
Alarm
8
O
Hand
D
Reset
On
13
Illustration 5.1 View of the LCP 21
MG06A502
Quick Guide
3
5
Quick Main
10
Menu Menu
11
12
10
Auto
On
14 15
Danfoss A/S © Rev. 06/2014 All rights reserved.
A. Numeric display
The LCD-display is back-lit with 1 numeric line. All data is
displayed in the LCP.
1 Set-up number shows the active set-up and the edit set-
up. If the same set-up acts as both active and edit set-up,
only that set-up number is shown (factory setting). When
active and edit set-up differ, both numbers are shown in
the display (Set-up 12). The number flashing indicates the
edit set-up.
2 Parameter number.
3 Parameter value.
4 Motor direction is shown in the bottom left of the display,
indicated by a small arrow pointing either clockwise or
counterclockwise.
5 The triangle indicates whether the LCP is in status, quick
menu or main menu.
Table 5.1 Legend to Illustration 5.1, Section A
Setup 12
AHP
VkW
srpm
Hz%
n1 n2 n3
p5 p4
INDEX
p3 p2 p1
Illustration 5.2 Display Information
B. Menu key
Press [Menu] to select between status, quick menu or main
menu.
C. Navigation keys and indicator lights (LEDs)
6 Green LED/On: Control section is working.
7 Yellow LED/Warn.: Indicates a warning.
8 Flashing Red LED/Alarm: Indicates an alarm.
9 [Back]: For moving to the previous step or layer in the
navigation structure
▲ ▼
10
Arrows [ ] [ ]: For maneuvering between parameter
groups, parameters and within parameters or increasing/
decreasing parameter values. Arrows can also be used for
setting local reference.
11 [OK]: For selecting a parameter and for accepting changes
to parameter settings
12
[►]: For moving from left to right within the parameter
value to change each digit individually.
Table 5.2 Legend to Illustration 5.1, Section C
5 5
23