Connecting Configuration Tool To Probe - VeEX RTU-4000 User Manual

6.2

Connecting Configuration Tool to probe

To connect the Probe Configuration Tool via Ethernet:
1. Click the Select Probe Type drop-down list box arrow, and then select RTU-4000.
2. Select the Ethernet Port option button and enter the RTU IP address.
The PC subnet address must match that of the RTU.
To connect the Probe Configuration Tool via Serial: (not supported at this time)
1. Click the Select Probe Type drop-down list box arrow, and then select RTU-4000.
2. Select the Serial Port option button and enter the RTU IP address.
3. Select the COM port on the PC that is assigned to the RS232-to-USB cable connecting
the probe to the PC.
RTU-4000/RTU-4100 User Manual, D07-00-132P-RevA01
Probe Configuration Tool: Connecting via Ethernet to Probe
Page 18 of 44