Table of Contents
Advertisement
TX50e e-Manual D07-00-009 REVA00
Define parameter step value
Press 'F1' to start/stop the generating process.
The "Jitter generation" submenu shows following parameters:
Transmit
Generated jitter parameters:
Frequency – Transmitted jitter frequency (20Hz... 100 kHz).
Level – Maximum peak-to-peak jitter (UIpp).
Receive
Current jitter value received signal.
Configuration
The Configuration menu (see Figure 5.26) provides the ability to configure analyzer's basic parameters, line
interface parameters.
To view information about software versions, press button.
Basic settings
The Basic settings submenu screen is shown at Figure 5.27.
Figure 5.25: "Jitter generation" submenu
Figure 5.26: "Configuration" menu
Page 27 of 30
Advertisement
Table of Contents
