Turning The Projector Off; Adjusting Offset - Christie Boxer 30 Installation And Setup Manual

LED

Turning the projector off

When powering off in preparation for inspection or maintenance, always disconnect from AC.
1. To turn the light source off using the projector keypad, press and hold the
hear a beep.
To turn off the light source using the remote, press and hold the OFF button until you hear a
beep.
When powering off the projector, allow the projector to complete its cool down cycle. Do not
immediately unplug the projector if this can be avoided.
2. To turn off power to the projector, disconnect from AC power.

Adjusting offset

Adjust the offset to align the image on the screen. Always adjust offset before adjusting boresight.
For the best optical performance and minimal keystone, use offsets instead of aiming at the center of
the image, in off-axis installations. Avoid extreme tilts or offsets. Corner vignettes on a white test
pattern indicate extreme offset that should be avoided using mechanical alignment.
1. Project an image with the primary lens.
Boxer 30 (Bb.2) Installation and Setup Guide
020-102017-08 Rev. 1 (02-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
State
On
Warming up
Cooling down
Hours exceed user limit
Failed to strike
Lamp off - Unknown
Lamp off - Interlock
Missing
Installation and setup
Description
Lamp is on.
Lamp is warming up.
Lamp is cooling down.
Displayed if the user set a warning
level and the hours exceed it.
Lamp failed to strike.
Lamp is off but the state is unknown
because the lamp driver could not
be communicated with.
Lamp is off due to an interlock being
triggered.
Lamp is not installed.
button until you
25