To connect AC power to the projector:
1. Connect AC power to the appropriate AC inlet on the projector.
2. If using full power mode, to ensure AC power cord does not fall out, pull down the safety latch
and lock in place.
To unplug, press tab and pull up the latch to release.
Turning the projector on
When the projector AC power supply is plugged in, the power is on.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
1. Plug the projector in to AC power.
The projector automatically powers on to standby mode when plugged in. The display panel
functionality becomes available.
2. To turn the light source on using the projector keypad, press and hold the power
until you hear a beep.
To turn on the light source using the remote, press and hold the ON button until you hear a
beep.
Related information
Power requirements (on page 42)
Projector LED status indicators
Identify the LED state colors and meaning.
LED
State
Blue
Solid
Flashing
Boxer 30 (Bb.2) Installation and Setup Guide
020-102017-08 Rev. 1 (02-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Description
Standby
Light source is off. Video electronics are off.
Projector status is OK.
Cool down
Projector is moving to one of the two standby
states:
• Light source is off and video electronics are
booting up.
Installation and setup
button
23