Resetting The Lens To Home Position; Adjusting Boresight - Christie Boxer 30 Installation And Setup Manual

2. Select a framing test pattern.
3. Select LENS OFFSET.
4. Use the arrows to adjust the offset to display a square image on the screen, with minimal
projector aiming error.
5. To exit to the home page, select Back.

Resetting the lens to home position

Realign the lens to the home position after the lens has been offset and out of alignment.
1. Select LENS OFFSET.
You can also select MENU > Configuration > Lens Settings > Lens Offset.
2. To reset the lens to the default home position, select Enter.
3. To confirm the reset, select OK.

Adjusting boresight

The boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector
tilt.
1. Close the shutter on the projector.
2. Unlock the three lens mount stabilization screws.
3. Open the shutter.
4. From the Test Pattern menu, select the Boresight test pattern.
The Boresight test pattern assists with adjusting the boresight for the three focus points.
Boxer 30 (Bb.2) Installation and Setup Guide
020-102017-08 Rev. 1 (02-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
26