Table of Contents
Advertisement
Back Panel
Thermo Scientific
The power entry module, the Ethernet port, and the 8-pin interconnect receptacle are located
on the back panel of the RI detector as shown in
terminals that allow you to connect a chart recorder or an integrator. See
description of the 16 terminals on the back panel of the RI detector.
Figure 2.
Back panel of RI detector
355 River Oaks Parkway
San Jose, CA 95134 U.S.A.
Table 1. Terminals on the back panel of the RI detector (Sheet 1 of 2)
Terminal No.
Label
1
GND
2
+5V@150mA
3
NC
4
RUN
5
READY
6
ZERO
7
GN
8
PURGE
9
RECORDER +
10
RECORDER -
Figure
2. The back panel also contains
8-pin interconnect
receptacle
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received,
including interference that may cause
undesired operation.
holder
Description
Ground terminal
Signal out Ready
External Signal in (AutoZero)
Ground terminal
External Signal In (purge On)
Recorder out
Recorder out
Surveyor RI Plus Detector Hardware Manual
1
Introduction
Back Panel
Table 1
for a
Ethernet
port
ENET
CAUTION
Disconnect Input Power Before Opening Cover
Service by Qualified Personnel
LINE
110V/220V 50/60HZ
110V T3.15AL 250V 100VA
FUSE
220V T1.6AL 250V 100VA
61010 - 1
Fuse
Power entry
module
3
Advertisement
Table of Contents
