Specifications - Thermo Scientific Surveyor RI Plus Hardware Manual

1
Introduction

Specifications

Specifications
10 Surveyor RI Plus Detector Hardware Manual
The Surveyor RI Plus Detector meets the following specifications.
Method of detection:
Refractive index range:
Attenuator range:
Linearity range:
Noise:
Rise time:
Polarity:
Zero adjustment:
Automatic zeroing range:
Resolution of autozeroing:
Offset adjustable range:
Resolution of offset:
Integrator output:
Recorder output:
External Communication:
Event Marker Input:
Signal Output:
Signal Input:
Temperature control:
Cell volume:
Maximum flow rate:
Pressure rating:
Liquid-contact materials:
Power Requirement:
Power consumption:
Dimensions:
Weight:
Deflection
1.00 to 1.75 RIU
0.25 to 512 μRIU
600 μRIU
-9
= 2.5 × 10 RIU (Response:1.5 seconds)
0.1, 0.25, 0.5, 1, 2. 3. 6 seconds
Positive/Negative
Optical zeroing, automatic zeroing
-5
± 10 × 10 RIU
-9
± 10 × 10 RIU
0 to 500 mV (same with Integrator output sensitivity)
10 mV (same with Integrator output sensitivity)
0 to 1V/FS (Sensitivity: 512 × 10
0 to 10 mV/FS
Ethernet
Contact: = DC 5V, 0.1 A
• Purge on/off
• Automatic zeroing on/off
• Run
Contact: = 5V, 0.1 A
Ready
Run, Autozero, Purge
30 to 50 °C (1 °C increment) or off
8 μL
10 mL/min (mobile phase: deionized water)
517 kPa (75 psi)
316 stainless steel, Teflon, Quartz optical glass
AC100/115/220/240 VAC ± 10%, 50/60 Hz
60 VA maximum
36 cm W × 47 cm D × 18 cm H
17.3 kg (38 lbs)
-6
RIU/FS)
Thermo Scientific