Setup And Operation; Starting And Shutting Down The Projector; Turn On The Projector; Turn Off The Projector - Eiki EK-450U Owner's Manual

Starting and Shutting down the Projector

Turn On the Projector

1.
Connect the power cord to the projector. Then connect the other end to a wall outlet.
Important:
Make sure that the Power switch is in the ON position.
2.
Turn on the connected devices.
3.
Turn on the projector by pressing the [
in keypad. The [
blink.
The projector splash screen displays and connected
devices are detected.
4.
If more than one input device is connected, press the [Source] button on the remote control to select an
input source.
5.
The projector detects the source you selected and displays the image.

Turn Off the Projector

1.
Press the [
projector. A warning message will appear on the displayed image.
2.
Press the [
your selection. If you do not press the [
after several seconds.
Caution:
Do not unplug the power cord until all of fans are stopped and the Power LED is blinking green.
] button on the built-in keypad is illuminated and the Status LED is Red with a long
] button on the built-in keypad or the [
] button on the built-in keypad or the [
On
Off
] button on the remote control or the [
Geometric
Correction PIP/PBP
F1 F2
Menu AV Mute
ENTER
Exit
Source Re-Sync
F3 F3
Volume D Zoom
Info. Freeze Remote
ID All
VGA HDMI1 HDMI2 Mode
1 2 3
HDBaseT USB Network Format
4 5 6
3D
7 8 9 0
On
Off ] button on the remote control to turn off the
Geometric
Correction PIP/PBP
F1 F2
Menu AV Mute
On
Off ] button on the remote control again to confirm
On
Off
] or [ Geometric ] button again, the warning message will disappear
ENTER
Correction PIP/PBP
Geometric
F1 F2
Correction PIP/PBP
Menu AV Mute
Exit
Source Re-Sync
F1 F2
F3 F3
Menu AV Mute
Volume D Zoom
ENTER
ENTER
Exit
Info. Freeze Remote
Source Re-Sync
ID All
F3 F3
Exit VGA HDMI1 HDMI2 Mode
Volume D Zoom
Source 1 Re-Sync 2 3
F3 F3
HDBaseT USB Network Format
4 5 6
Volume D Zoom
3D
7 8 9 0
Info. Freeze Remote
ID All
VGA HDMI1 HDMI2 Mode
Info. Freeze Remote
1 2 3
ID All
HDBaseT USB Network Format
VGA HDMI1 HDMI2 4 Mode 5 6
1 2 3
13
3D
— —
HDBaseT USB Network Format
7 8 9 0
4 5 6
3D
7 8 9 0
DLP Projector — Owner's Manual
S
etup and
] button on the built-
O
peratiOn