Table of Contents
Advertisement
Remote Control Operating Range
The remote control uses infrared transmission to control the projector. It is not necessary to point the
remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or the
rear of the projector, the remote will function well within a radius of about 10 meters (32.8 feet) and 30
degrees above or below the projector level. If the projector does not respond to the remote control, move
a little closer.
Projector and Remote Control Buttons
The projector can be operated using the remote control or the buttons on the rear of the projector. All
operations can be carried out with the remote control; however, the buttons on the projector are limited in
use.
Remote Control Code
The 100 different remote control codes (Remote ID, Code 00 - Code 99) are assigned to this projector.
Switching the remote control codes prevents interference from other remote controls when several
projectors or video equipment next to each other are being operated at the same time. Change the remote
ID on both projector and remote control.
To change the remote ID for the Remote Control:
Press and hold the [Remote ID] button for more than 3 seconds, and the LED indicator (above the [Off]
button of the remote control unit) starts blinking slowly.
Then, input the number between 00-99 by pressing the [0]~[9] buttons to switch the remote ID within 10
seconds.
After entering 2 digit of remote ID, the LED indicator will flash quickly for 3 times that indicates the remote
ID was changed.
Default setting: 00
D
t
evIce
ype
Remote Control Unit
Projector
To change the remote code for the projector:
Press the [Menu] button to open the OSD menu. Press the [p]/[q] button to select Setup and press the
[Enter] button to enter the Setup menu.
Press the [p]/[q] button to select Remote Settings, and press the [Enter] button to enter the Remote
Code submenu.
Press the [p]/[q] button to select Remote Code, then choose the number (00-99) by pressing the [t]/[u]
button to set up the remote code.
Default setting: 00
To reset the remote ID:
Press the [Remote All] button for 3 seconds, and the LED indicator will flash quickly for 3 times that
indicates the remote ID was reset to default (00).
00
01
00-99
01
11
—
DLP Projector — Owner's Manual
r
ID
emote
02
02
—
03
....
99
03
.....
99
Advertisement
Table of Contents
