Eiki EK-450U Owner's Manual page 48

DLP Projector — Owner's Manual
I
tem
H. Position
V. Position
Frequency
Tracking
Edge Mask
Digital Zoom
Projection Mode
Image Shift
Geometric Correction
PIP/PBP
Move the image right or left within the area of available pixels (VGA signal).
• Press the [t] button to move the image left.
• Press the [u] button to move the image right.
Move the image up or down within the area of available pixels (VGA
signal).
• Press the [t] button to move the image down.
• Press the [u] button to move the image up.
Changes the display data frequency (VGA signal) to match the frequency
of your computer's graphic card. When you experience a vertical flickering
bar, use this function to make an adjustment.
Synchronizes the signal timing (VGA signal) of the display with the
graphics card. If you experience an unstable or flickering image, use this
function to correct it.
Use this function to remove the video encoding noise on the edge of video
source.
Use to reduce or magnify an image on the projection screen.
Select the preferred projection:
Front, Front Ceiling, Rear, and Rear Ceiling.
Use this function to shift the image horizontally or vertically.
Configure the image correction settings.
See "Geometric Correction" on page 33.
Configure the PIP/PBP settings. See "PIP/PBP" on page 34.
32
—
D
escrIptIon
—