Table of Contents
Advertisement
I
tem
Signal Power On
Auto Power Off (min.)
Sleep Timer (min.)
Standby Power Mode
IR Control
PIN Protect
Change PIN
HDMI 1 EDID
Reset
Enable or disable the signal power on function.
•
Off: Disable the power on trigger by active signal is detected.
•
On: The projector powers on automatically when an active signal is
detected.
Note:
• The applied terminals for this function are HDMI1/2, VGA and
HDBaseT.
• "Signal power on" works depending on the following two settings:
a. Signal Power ON
b. Standby Power Mode
Automatically turn the projector off after no signals are detected for a preset
number of minutes. If an active signal is received before the projector
powers down, the image will be displayed. (Setting time from 0 ~ 120
minutes, with 5 minutes increments)
Once it starts to counting down, press the [EXIT] button on the projector
keypad or the [Exit] button on the remote control to stop the countdown
timer.
Set the time before the projector automatically turns off.
See "Sleep Timer (min.)" (page 46) for details.
Restrict some functions in the standby mode to reduce power consumption.
See "Power Mode (Standby) Table" (page 44) for details.
Select the IR control:
Front, Top, and Both.
Enable this function to prompt for a password before using the projector.
•
Off: Allow you to turn on the projector without password verification.
•
On: Need to use the security verification when turning the projector on.
Set or modify the password that is prompted when turning the projector on.
The default PIN code is "1234".
Set the HDMI 1 EDID setting to either 2.0 or 1.4.
•
HDMI 2.0 resolution:
Video & PC Graphics: up to 4K (3840x2160@60Hz) and 4K
(4096x2160@60Hz)
•
HDMI 1.4 resolution:
Video & PC Graphics: up to WUXGA (1920x1200@60Hz)
Reset the projector to the default settings, except H. Keystone/V. Keystone
setting.
43
—
DLP Projector — Owner's Manual
D
escrIptIon
—
Advertisement
Table of Contents
