Setup And Operation; Starting And Shutting Down The Projector; Turn The Projector On; Turn The Projector Off - Eiki EK-800U Owner's Manual

DLP Projector — Owner's Manual

Starting and Shutting down the Projector

Turn the Projector On

1.
Connect the power cord to the projector. Connect the other end to a wall outlet.
The Power button on the built in keypad is illuminated.
2.
Turn on the connected devices.
3.
Turn on the projector by pressing "
or press " " on the built-in keypad. The Status LED is
Green with a long blink.
The projector splash screen displays and connected
devices are detected.
4.
If more than one input device is connected, press the Source key
on the remote control and use ▲▼ to select an input source (VGA,
BNC, HDMI, HDBaseT, or Component).
5.
The projector detects the source you selected and displays the
image.

Turn the Projector Off

1.
Press " " on the built-in keypad or press "
message will appear on the displayed image
2.
Press " " on the built-in keypad or press "
you do not press "
Caution:
• Do not unplug the power cord until all of fans are stop–indicating the projector has cooled down.
" on the remote control
" or " " again, the warning message will disappear after 3 seconds.
" on the remote control to turn off the projector. A warning
" on the remote control again to confirm your selection. If
10
— —
S O
etup and peratiOn