Table of Contents
Advertisement
Monitoring and Controlling
No-signal (No Signal)
No Signal is input to the projector. Check the connection status or check
that the power for the signal source is turned on.
Lens shift error (Lens shift error)
No lens (No lens)
Pump Error (Pump Error)
Shutter Warning (Shutter Warning)
Shutter Error (Shutter Error)
Power Err. (Voltage) (Supply Voltage Error)
See the following to deal with problems or warnings.
"Reading the Indicators"
s
Management Using SNMP
By setting SNMP to On in the Configuration menu, notification messages
are sent to the specified computer when a problem or warning occurs. This
allows you to check for problems with projectors even at locations away
from the projectors.
Network - Notifications - SNMP
s
a
SNMP should be managed by a network administrator or someone
who is familiar with the network.
To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
The SNMP Agent for this projector complies with version 1
(SNMPv1).
The managing function using SNMP cannot be used over wireless
LAN in Quick connection mode.
Up to two destination IP addresses can be saved.
p.175
p.159
ESC/VP21 Commands
You can control the projector from an external device using ESC/VP21.
Command list
When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
The main contents are listed below.
Item
On
Power ON/OFF
Off
Computer
Signal selection
BNC
HDMI
LAN
SDI
DVI-D
HDBaseT
239
Command
PWR ON
PWR OFF
Auto
SOURCE 1F
RGB
SOURCE 11
Component
SOURCE 14
Auto
SOURCE BF
RGB
SOURCE B1
Component
SOURCE B4
SOURCE 30
SOURCE 53
SOURCE 60
SOURCE A0
SOURCE 80
Advertisement
Table of Contents
