Reflecting Saved Settings To Other Projectors - Epson EB-L30002U User Manual

Batch Setup

Reflecting saved settings to other projectors

a
Turn off the main power switch while the power cord is connected
to the projector, and check that all of the projector's indicators
turn off.
b
Connect the USB flash drive on which the settings are saved to the
projector's USB-A port.
a
 When the USB flash drive contains 1 to 3 types of batch
setup files, the file is reflected to the projector with the same
model number. If there are multiple files for a projector with
the same model number, the settings may not be reflected
correctly.
 When there are four or more types of batch setup files on the
USB flash drive, the settings may not be reflected correctly.
 Do not store any data except for the batch setup file on the
USB flash drive. If the USB flash drive contains data other
than the batch setup file, the settings may not be reflected
correctly.
c
While holding down the [Menu] button, turn on the main power
switch.
When the projector's indicators turn on as follows, release
the [Menu] button.
Power Status
Blue - On Blue - On
The indicators remain on for about 75 seconds.
When all of the indicators start flashing, the settings are being
written.
Caution
 Do not disconnect the power cord from the projector or turn off the
main power switch while the settings are being written. If power is not
being supplied, the projector may not startup correctly.
 Do not disconnect the USB flash drive from the projector while the
settings are being written. If the USB flash drive is disconnected, the
projector may not start correctly.
Laser Temp
Orange - On Orange - On
168