Festo Compact Performance CP-FB6-E Manual page 52

2. Commissioning
If you use the controllers of another manufacturer as
master on the INTERBUS, you can set the process
data word to suit your addressing. To do this, set DIL
switch element 4 to ON = Standard mode (controller
manufacturer other than Siemens ). The high byte (byte
n+1) and the low byte (byte n) will then be swapped.
CAUTION
• When replacing a CP field bus node CP-FB6-E,
You thereby avoid errors in addressing the inputs/out-
puts.
Standard mode: structure of process data word
High byte (byte n+1)
15 14 13 12 11
DIL switch element 4: ON = Standard mode (manufacturer other than Siemens)
Fig. 2/3: Structure of process data word in Standard mode with
manufacturers other than Siemens
CP FB6-E 9809c
make sure that the DIL switch is correctly set.
10 9 8 7
4
Low byte (byte n)
6 5 4 3 2 1 0
2-23