2. Commissioning
2.2.3 Bus configuration without CMD software
The CP system supports the following addressing and
programming variants, depending on the module you
are using:
– logical addressing
– physical addressing
Logical addressing
PLEASE NOTE
• ID CODE
1)
One or more configuration lists have been created in
the PLC or in the INTERBUS module for logical ad-
dressing. These lists contain at least the following en-
tries:
– the ID codes of all slaves
– the logical addresses of all slaves
– the number of inputs
– the number of outputs
2-12
Always configure a CP system (with inputs and
1)
outputs
) with Ident code 3.
Valve coils and/or electrical outputs
CP FB6-E 9809c