Configuration; Addressing The Inputs/Outputs - Festo Compact Performance CP-FB6-E Manual

2. Commissioning

2.4 Configuration

2.4.1 Addressing the inputs/outputs

Further specifications on addressing and programming
can be found in the manuals for your controller and the
INTERBUS module.
PLEASE NOTE
A CP valve location occupies two addresses.
The following applies:
- lower-value address:
- higher-value address:
The address assignment (process data assignment) of
the CP inputs/outputs and of the CP valve terminal on
the INTERBUS or compatible bus systems depends
principally on the INTERBUS module and your control-
ler.
CAUTION
There are different address assignments on the
INTERBUS. This is due to the assignment of the
processing data within the INTERBUS module and
not within the Festo CP system.
• Make sure that DIL switch element 4 is set
• Observe the position of the high and low bytes
You thereby avoid errors in addressing the inputs/out-
puts.
CP FB6-E 9809c
correctly for your addressing (see chapter 1).
(byte n/n+1) when assigning the addresses for the
CP system, as the position of these bytes may be
swapped in the case of some control systems.
pilot solenoid 14
pilot solenoid 12
2-19