13 Charging The Remote Control  26; 14 Completing The Fitting 26 - Otto Bock Genium X3 Instructions For Use Manual

Remote control
1 To change the active connection, select the name of the current connection in the main menu and press enter
to confirm
2 In the list of saved connections which is then displayed, select the required connection and press enter to
confirm
3 If the chosen connection cannot be re-established, a reduced main menu appears Choose "Select device"
to activate another selected connection In some cases following service, the connection cannot be restored
even though the joint is within range of the remote control In this case, the existing connection must be erased
and the pairing process has to be completed again
6.13 Charging the remote control
INFORMATION
Advise your patients of the information in this section
Disconnect the charging cable from the charger for the knee joint and connect it to the charging receptacle of the
remote control Depending on how often the remote control is used, it should last two months on a single charge
The battery charge level of the remote control is shown at the top left of the display (see Fig1, Section 63 "Initial
Connection between the remote control and the knee joint (Pairing)") Fully charging the remote control battery
takes a maximum of 3-4 hours
6.14 Completing the Fitting
CAUTION
Securing the screws. If the screws are not secured properly, loss of functionality due to structural failure may
result This may cause the patient to fall
• The screws must be secured in order to ensure operating reliability
• Upon finalising all settings, all screws must be fastened and tightened to the proper torque (see Section 3
"Torque values of the screw connections")
• The screws must then be secured with 636K13 Loctite
26 | Ottobock Genium X3 - Bionic Prosthetic System