11 Managing Prosthesis  25; 12 Connecting To The Prosthesis During Normal Operation 25 - Otto Bock Genium X3 Instructions For Use Manual

7 Information about the firmware version of the knee joint and signal strength is accessible under "Info" Select
the arrow symbol to return to the main menu on the display
6.11 Managing Prosthesis
Connections with up to four different prostheses can be stored in a single remote control Conversely, a prosthe-
sis can only be connected to a single remote control Complete the following steps to add additional connections:
1 In the main menu, use to select "RC Settings" and press enter to confirm
2 Select "Pairing" from the menu that appears
3 The remote searches for other prostheses in range (display: "Device scan")
4 Press the enter button to confirm if another prosthesis is found If several additional prostheses are found, the
serial number of the desired prosthesis has to be selected using the navigation keys (display: serial number)
Press to select one of the four items and press the enter button to confirm One of the existing connections
can also be overwritten The configuration files are loaded from the prosthesis and the main menu is displayed
To delete an existing connection, please follow the steps below:
1 In the main menu, use to select "RC Settings" and press enter to confirm
2 In the menu which is then displayed, select "Delete Connection" and press enter to confirm
3 Use to select the connection to be deleted and press enter to confirm
6.12 Connecting to the Prosthesis during Normal Operation
INFORMATION
Advise your patients of the information in this section
If more than one connection has been saved, a selection menu for the saved connections appears after powering
up; the most recently active connection is pre-selected here
Genium X3 - Bionic Prosthetic System
Remote control
Ottobock | 25