65 Mymode Switching Via Remote Control 21; 66 Changing Prosthesis Settings 21 - Otto Bock Genium X3 Instructions For Use Manual

6.5 MyMode Switching via remote control
INFORMATION
Advise your patients of the information in this section
Once an active connection to the prosthesis has been established, the remote control can be used to switch
between MyModes
1 Select "Mode" in the main menu and press the enter button to confirm
2 A list of the available MyModes is displayed Press to select the required MyMode and the enter button
to confirm If you open the MyMode list by accident, you can select the active MyMode again
• Feedback from the prosthesis: 1 long vibration signal
3 You can switch off the remote control by selecting and confirming "RC Power off"
6.6 Changing Prosthesis Settings
INFORMATION
Advise your patients of the information in this section
Once an active connection to the prosthesis has been established, the settings of the respective MyMode can be
modified with the remote control
1 Select "Device Settings" in the main menu and confirm the selection
2 A list of the available settings for the current MyMode is displayed Select the desired parameter and confirm
3 A screen with a scale, the current parameter value and the limit values is displayed Press to change the
setting as required and press the enter button to confirm
4 The list of parameters can be closed without making changes by selecting and confirming the arrow symbol
Press to access the arrow symbol
5 Select and confirm "RC Power off" to switch off the remote control
Genium X3 - Bionic Prosthetic System
and 1 long beep signal
Remote control

Ottobock | 21