Configure Camera Settings - Polycom G7500 Administrator's Manual

Configure Camera Settings

You can configure settings for cameras connected to your G7500 system. When you connect a supported
camera, the system automatically discovers it and displays the available camera settings in the system
web interface.
See the latest release notes for specific information about the cameras you can use with your G7500.
Note: If you connect an unsupported camera, the system still attempts to show video. Polycom
can't guarantee that the results are optimal or that the available settings are the same as a
supported camera.
Procedure
1. In the system web interface, go to Audio/Video > Video Inputs.
2. Go to General Camera Settings.
3. Configure the following settings:
Setting
Allow Other Participants In a Call to Control
Your Camera
Power Frequency
Enable Camera Preset Snapshot Icons
Polycom, Inc.
Configuring Video and Camera Settings
Description
Specifies whether the far site can pan, tilt, or zoom
the near-site camera. When you enable this setting,
a user at the far site can control the framing and
angle of the camera for the best view of the near
site. This is also called Far End Camera Control
(FECC).
Specifies the power-line frequency for your system.
Your system typically defaults to the correct power-
line frequency based on the video standard used in
the country where it's located. This setting helps
you adapt the system to areas where the frequency
doesn't match the video standard. You might also
need to change this setting to avoid flicker from
fluorescent lights in the room.
Enables the use of snapshot icons that represent
camera presets.
To see a preset icon, you must enable this setting
before configuring the preset.
79