Polycom G7500 Administrator's Manual page 15

Pair an IP Peripheral Device Automatically
IP peripheral devices automatically pair with your G7500 system by default when you connect them to the
system. For example, when you connect a Polycom IP Table Microphone, it pairs automatically and is
ready to use.
Procedure
» Connect the peripheral device to an LLN port
If paired successfully, the device displays under Paired Devices with a Connected status. If a
device shows a Disconnected status, this indicates that pairing wasn't successful.
Disable Automatic Pairing
You can disable automatic pairing for your G7500 system.
If you disable automatic pairing, you must connect and manually pair a peripheral device in the system
web interface to use it.
Procedure
1. In the system web interface, go to General Settings > Device Management.
2. Clear the Enable New Device Auto-Pairing check box to disable automatic pairing.
Pair an IP Peripheral Device Manually
If you disable automatic pairing, you must manually pair an IP peripheral device to use it with your G7500
system.
Procedure
1. Connect the peripheral device to an LLN port
2. In the system web interface, go to General Settings > Device Management.
3. Under Available Devices, find the device and select Pair.
If paired successfully, the device displays under Paired Devices with a Connected status. If a
device shows a Disconnected status, this indicates that pairing wasn't successful.
Unpair an IP Peripheral Device
If you don't want to use an IP peripheral device with your G7500 system anymore, unpair it in the system
web interface.
Don't unpair peripheral devices you plan to use with your system again. For example, if you move your
entire system to another room, just disconnect the devices and reconnect them in the new location.
Note: If you manually unpair a peripheral device, it won't automatically pair again with this system.
Procedure
1. In the system web interface, go to General Settings > Device Management.
2. Under Paired Devices, find the device and select Unpair.
The unpaired device moves from Paired Devices to Available Devices (which shows discovered
devices you can pair with the system).
Related Links
Move a Microphone Adapter to Another Location
Polycom, Inc.
on the back of your system.
on the back of your system.
on page 18
Setting Up the System
13