Configure Dns Settings Manually; Configure Wired Lan Options - Polycom G7500 Administrator's Manual

Setting
Subnet Mask
Default Gateway
4. Select Save.

Configure DNS Settings Manually

You can manually configure the DNS server settings for your G7500 system.
If your system gets its IP address automatically, you can't configure these settings. They display as read-
only.
Procedure
1. In the system web interface, go to Network > DNS.
2. Enter your DNS server address (you can enter up to four addresses).
3. Select Save.

Configure Wired LAN Options

You can configure LAN properties for your G7500 system in the local interface or the system web
interface.
Procedure
1. In the system web interface, go to Network > Primary Network > LAN Options.
2. Configure the following settings:
Setting
Host Name
Domain Name
Polycom, Inc.
Configuring Network Settings
Description
Specifies the subnet mask assigned to your
system.
Specifies the default gateway assigned to
your system.
Description
Indicates your system name. If the system
discovers a valid name during setup or a software
installation, the system automatically creates the
host name. However, if the system finds an invalid
system name, such as a name with a space, the
system creates a host name using the following
format: SystemType-xxxxxx, where xxxxxx is a
set of random alphanumeric characters.
IPv4 networks: The system sends the host name
to the DHCP server to attempt to register the name
with the local DNS server or look up the domain
where the system is registered (if supported).
Identifies the domain your system belongs to.
If the system doesn't automatically obtain a domain
name, enter one here.
28