Local Transient Operation; Continuous Mode - Ametek Amrel PLA Series Operation Manual

LOCAL TRANSIENT OPERATION

LCL Operation:
STEP Selection
MENU/LOCAL → LOAD CONTROL → STEP PARAM.
OTHER TRANSIENT OPERATION SELECTIONS
Remote Only – Trigger Operation
CONT Hot Key – Continuous Operation
TOGGLE Hot Key – Toggle Operation
SINGLE Hot Key – Pulse Operation
STEP Hot Key – Step Operation
TRIGGER Hot Key – Front Panel Trigger

CONTINUOUS MODE

In continuous mode, the eLoad input switches between 2 user defined levels; main and transient. The duty cycle and
frequency are user defined.
i
i
Transient
Level
Main
Level
Typical application: Testing the Load Regulation (Effect) of a power Supply, defined as the voltage change in dc output
due to a change in load current from minimal resistance (closed circuit) to maximum resistance (open circu it). The PLW
can be programmed to switch between any two current levels.
LCL Operation:
1. Using the mode hot keys, select operating mode (CC, CV, CR, CP)
2. Set the MAIN level by holding down the encoder and rotate to change the value or enter numerically.
Set the Transient level by pressing the "PEAK" hot key and edit the value using the encoder or enter manually.
3.
Select Continuous transient operation by pressing the "CONT" hot key.
4.
Set the duty cycle and frequency by pressing the "DUTY" and "FREQ" hot keys and tapping t he encoder to edit
5.
each. The duty cycle can be set from 2% to 98% and the frequency from 0.1Hz to 10 KHz. Rotate the encoder
clockwise or counterclockwise to change values or enter manually.
Set the Rising and Falling Slew Time by pressing "SLEW," rotate the encoder to select option, tap the encoder
6.
to edit slew time value and press "ENTER" to confirm value entry.
To begin the continuous transient operation, press the "PULSE" hot key (pulse hot key will blink) and then press
7.
the "INPUT" hot key to activa te the Continuous transient operation.
M470039-01 REV-F
→STEP
→STEP AUTO
→STEP ONCE
t
Page 83