Ametek Amrel PLA Series Operation Manual page 159

Proofed test cases can be saved to disk as a ,ini file for repeatedly accessing, which will backup/restore all
parameters in Control Panel. Refer to File->Profile menu shown below.
Descriptions of Meter, I-V Graph, and P-V Graph
While Meter can be shown on desktop when system connect to device. I-V graph, and P-V graph can ONLY
be shown on desktop, when there are valid data captured by system.
We can monitor device status by the measured voltage, measured current, and measured temperature shown on
meter panel (see below), when we check bullet of meter
In the I-V graph (see below), X axis define configured value for each step of specified mode, left Y axis define
measured voltage value, and right Y axis define measured current value.
The meanings for fields at the bottom of graph,
Vmax - maximum measured voltage.(@ at the right is its value of X axis)
Vmin - minimum measured voltage.(@ at the right is its value of X axis)
Imax - maximum measured current.(@ at the right is its value of X axis)
Imin - minimum measured current .(@ at the right is its value of X axis)
V - cursor values of left Y axis for measured voltage in blue color
I - cursor values of right Y axis for measured current in green color
M470039-01 REV-F
Profile Load & Save
Description of Meter
Description of I-V Graph
.
Page 158