Ametek Amrel PLA Series Operation Manual page 153

Installation Procedures:
Locate both the top and bottom FLUID INLET copper pipes.
Locate both the top and bottom FLUID OUTLET copper pipes.
Inlet top
Inlet bottom
Use pipe thread sealant PTFE tape wrap approximately 3 to 4 times around each pipe male
threads of each interconnect pipe, to ensure a tight seal and to prevent leak. Thoroughly clean
the male and female thread and wrap the tap in the direction of the thread spiral. PTFE tape
will not be included in the kit.
Install Plastic Round Shims (O-Rings) onto distribution pipes as picture below.
M470039-01 REV-F
Outlet top
Outlet bottom
Page 152