Ametek Amrel PLA Series Operation Manual page 150

10) Inspect the rubber diaphragm to verify the defect/damage.
11) Contact AMREL Technical Support and report the defective valve. A replacement will be
shipped shortly
12) Replace the rubber diaphragm and reconnect it back with the metal solenoid assembly.
Make sure the metal stub forms a snug fit with the rubber diaphragm groove (blue arrow).
Now, follow steps 5 ~ 8 in the Maintenance Check Section to reinstall the solenoid valve assembly.
M470039-01 REV-F
Good
Tear
Page 149