Calibration Configuration; Calibration Parameters - Ametek Amrel PLA Series Operation Manual

CALIBRATION CONFIGURATION

There are two configurations for the calibration of the electronic load. One is for measuring voltage and the
other for measuring current.
0.01
CURRENT
SHUNT
FIGURE 5.1 – CALIBRATION SETUP CONFIGURATION

CALIBRATION PARAMETERS

The following are the parameters that are calibrated.
•
CV main level programming.
•
CC low range main level programming.
•
CC high range main level programming.
•
CR low range main level programming.
•
CR middle range main level programming.
•
CR high range main level programming.
•
CP low range main level programming.
•
CP high range main level programming.
•
CV transient level programming.
•
CC low range transient level programming.
•
CC high range transient level programming.
•
CR low range transient level programming.
•
CR middle range transient level programm ing.
•
CR high range transient level programming.
•
CP low range transient level programming.
•
CP high range transient level programming.
•
CV readback.
•
CC low range readback.
•
CC high range readback.
M470039-01 REV-F
PLW
INPUT
+ -
+
POWER SUPPLY
+
−
−
+
−
DMM
)
(VOLTAGE
DMM
)
(CURRENT
Page 105