Trigger Operation - Ametek Amrel PLA Series Operation Manual

DC Power Supply

TRIGGER OPERATION

Figure 2.5 depicts the method of triggering the Electronic Loads. The TRIGOUT signal of the Electronic Load is
connected to the Trigger input of the DMM. Additional instruments can be daisy chained to a DMM in the same manner.
Once the preset settings of the instruments have been programmed, one trigger signal can simultaneously set all
instruments to their transient settings.
Note: Trigger Operation is Negative-Edge Triggered
M470039-01 REV-F
+
(+)
_
(-)
FIGURE 2.5 PARALLEL CONFIGURATION
PROGRAMMING
ELECTRONIC
LOAD
–
+
PROGRAMMING
ELECTRONIC
LOAD
–
+
Page 55