Front Panel Keypad Description; Hot Key Description - Ametek Amrel PLA Series Operation Manual

Front Panel Keypad Description

FIGURE 1.2 FRONT PANEL KEYPAD
Key "0" Numeric entry key for number 0.
Key "." Numeric entry key for decimal dot.
Key "1" Numeric entry key for number 1.
Key "2" Numeric entry key for number 2.
Key "3" Numeric entry key for number 3.
Key "4" Numeric entry key for number 4.
Key "5" Numeric entry key for number 5.
Key "6" Numeric entry key for number 6.
Key "7" Numeric entry key for number 7.
Key "8" Numeric entry key for number 8.
Key "9" Numeric entry key for number 9.

Hot Key Description

HOT KEYS
INPUT
SHORT
STEP
PULSE
CC
CR
CP
CV
CONT
TOGGLE
SINGLE
TRIGGER
PEAK
FREQ
DUTY
SLEW
TABLE 1.2 – HOT KEY DESCRIPTION
M470039-01 REV-F
7
4
1
0
OFF
INPUT OFF
SHORT OFF
STEP OFF
PULSE OFF
CC Mode Disabled
CR Mode Disabled
CP Mode Disabled
CV Mode Disabled
Continuous Disabled
Toggle Disabled
Single Disabled
N/A
Setting not Enabled
Setting not Enabled
Setting not Enabled
Setting not Enabled
8 9
5 6
2 3
•
CLEAR
Key "CLEAR" Clears partially set commands and
Note: If the model name exceeds 16 digits, the displayed
model name will truncate. Please refer to the m odel name
label or use *IDN? Command to query back model name
Key "RANGE" Selects between auto, manual low,
Key "LOCAL" Returns from remote PC control to local
Key "STEP"
Key "ENTER" Enters the values in the set mode and
SOLID ON
INPUT ON
SHORT ON
STEP ON
PULSE ON
CC Mode Enabled
CR Mode Enabled
CP Mode Enabled
CV Mode Enabled
Continuous Enabled
Toggle Enabled
Single Enabled
N/A
Adjust Trans. Value
Adjust Trans. Freq.
Adjust Trans. Duty
Adjust +/- Slew Rate
MENU
LOCAL
RANGE
STEP
ENTER
return the unit to the metering mode. By
pressing the "Clear" with no entry will
display "AMREL Model number and
software version.
manual middle and manual high range.
operation and status indicator will
change from RMT to LCL. The Local
key also accesses all eLOAD menu
options and parameters for configuring
desired settings.
Allows programming of time duration
and value settings for step operation
returns the unit to the metering mode.
FLASHING ON
Press to Short
Press to Short
Press Input to Start Step
Press Input to Start Pulse
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Trigger Transient Operation
N/A
N/A
N/A
N/A
Page 23