Restarting; Modbus Service - Sungrow Logger3000 User Manual

User Manual
Default IP address of the ETH2 is 192.168.1.100.

9.9.4 Restarting

This function is used to restore factory settings or restart the Logger3000.
Click "Settings" -＞ "Restart" to enter the corresponding interface.
O O p p e e r r a a t t i i o o n n
Restart
Timing restart
Restore factory
settings
The modification of parameters (serial port parameters, network parameters,
and service configuration) will not be valid before the system is restarted.

9.9.5 Modbus Service

This function is used to configure the Modbus service of the Logger3000. The method is
as follows:
Click "Settings" -＞ "Modbus services" to enter the corresponding interface.
Click "Forwarding service cfg." to view the configuration information.
•
Click "Network port" to set network port parameters.
•
If the access IP is set to "0.0.0.0", any background device with valid IP address
can access the Logger3000. If the access IP is set to a specific value, only this
background can access the Logger3000.
D D e e s s c c r r i i p p t t i i o o n n
Performed to restart the Logger3000.
Tick "Timing restart", select the time, and click "Save", so that
the Logger3000 will be restarted at the set time.
Click "Restore factory settings" to clear all information except
for IP address of the Logger3000.
9 Web Interface
45