Procedure B - YASKAWA MECHATROLINK-II SI-T3 Technical Manual

5 Installation Procedure
■

Procedure B

This section shows the procedure to install and wire the option on a GA700, GA800, CR700, or CH700 drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive GA700, GA800, CR700, or CH700, make sure that the
option software version is PRG: 6108 or later.
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. Refer to the following figure for an exploded view of the drive with the option and related components
for reference in the installation procedure.
A - Insertion point for CN5 connector
B - Option
C - Included screws
D - Drive front cover
E - LED label
F - Keypad
Install the Option
Remove the front covers of the drive before you install the option. Refer to the drive manual for information about
how to remove the front covers. Different drive sizes have different cover removal procedures. You can only
install this option into the CN5-A connector on the drive control board.
DANGER
Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an energized drive. Before
servicing, disconnect all power to the equipment and wait for the time specified on the warning label at a minimum. The internal
capacitor stays charged after the drive is de-energized. The charge indicator LED extinguishes when the DC bus voltage
decreases below 50 Vdc. When all indicators are OFF, measure for dangerous voltages to make sure that the drive is safe. If
you do work on the drive when it is energized, it will cause serious injury or death from electrical shock.
1.
Put the LED label (A) in the correct position on the drive front cover (B).
A - LED label
16
Figure 5.9 Drive Components with Option
Figure 5.10 Put the LED Label on the Drive Front Cover
G - Option modular connector CN3
H - LED Status Ring board
I - Connector CN5-A
J - Connector CN5-B (Not available
for communication option
installation.)
K - Connector CN5-C (Not available
for communication option
installation.)
B - Drive front cover
YASKAWA SIEP C730600 86F MECHATROLINK-II Technical Manual