YASKAWA MECHATROLINK-II SI-T3 Technical Manual page 13

2.
Put the LED label (B) in the appropriate position on the drive front cover (A).
A - Drive front cover
3.
Insert the option card (A) into the CN5-A connector (C) on the drive and use the included screws (B) to put
it in place.
A - Option
B - Included screws
4.
Connect one end of the ground wire (C) to the ground terminal (B) using one of the remaining provided
screws (D). Connect the other end of the ground wire (C) to the remaining ground terminal and installation
hole on the option (A) using the last remaining provided screw (D).
• Tighten the screws to 0.5 to 0.6 N•m (4.4 to 5.3 in•lb).
A - Option
B - Drive grounding terminal (FE)
YASKAWA SIEP C730600 86F MECHATROLINK-II Technical Manual
Figure 5.3 Put the LED Label on the Drive Front Cover
Figure 5.4 Insert the Option
Figure 5.5 Connect the Ground Wire
B - LED label
C - Connector CN5-A
C - Ground wire
D - Included screws
5 Installation Procedure
13