GE eBike II Series Service Manual page 180

2018111-219 SPARE EBIKE EL MOTOR TRANSVERSE ANGLE SCU
2018111-220 EBIKE EL MOTOR CONTROLER FIRMWARE UPGRADE KIT
Instruction
GE Healthcare
eBike EL
Motor Controller Firmware Installation
2018111-341 A
17 March 2017
Introduction
The eBike EL Motor Controller Firmware Update is intended for GE Healthcare Field
Engineers.
The purpose of this manual is to update the firmware in the eBike EL Motor Controller
from revision 11 to 12.
Affected eBike
Motor controller firmware on eBike EL V2 type SKF Actuation System
Affected Part Numbers Description
2018111-213 SPARE EBIKE EL MOTOR CONTROLLER 240V
2018111-214 SPARE EBIKE EL MOTOR CONTROLLER 120V
Required Equipment
The following equipment is required for the update:
• Firmware upgrade kit
Includes this instruction document and revision label.
• Laptop or personal computer running Microsoft Windows 7 or 8.1 OS
NOTE:
The term "PC" is used throughout this document to indicate laptop or personal
computer.
GE Medical Systems Information Technologies, Inc., a General Electric
Company, going to market as GE Healthcare.
8200 West Tower Avenue Milwaukee, WI 53223 U.S.A.
© 2017 General Electric Company.
All Rights Reserved.
2018111-194 SPARE EBIKE II L&EL CLAMPING LEVER SET
2018111-104 SPARE EBIKE L&EL CLMPG LVR SET HANDGRIP
- 180 -
Service Kit: Motor l laterral tilt for eBike EL
1x motor, lateral tilt (motor max. 10°) for eBike EL
2x stud screw SW19
2x washer U24
2x washer U13
4x ring Hostaform D. 30
2x nut M12, self-locking
3x cable tie 95 mm
Firmware Upgrade Kit: Motor Controler for eBike EL
eBike EL motor controler firmware instruction installation
Label eBike EL motor controler firmware version
Service Kit: Clamping lever kit for eBike L/EL
1x clamping plate 30x8x34
1x reinforcing angle 34.3x25x2
1x star knob M10x15
Service Kit: Clamping lever kit for handgrip tube
1x clamping sleeve for handgrip tube, complete
2x star washer 5.3
1x screw M5x6
1x Novo Grip clamping lever M10x15
eBike II, eBike II L, eBike II EL 2018112-069 Rev. F