s
(
addle Motor exCHange
•
Remove the housing of the ergometer.
Note
Position the saddle at mid-level before removing the saddle
motor
•
Disconnect connection cable of the saddle motor from
PCB Interface MAE
•
Remove the saddle and pull off the bellows.
•
Remove saddle host - to do so, unscrew both screws
at the top, push down the saddle tube to allow the
cylindrical pin to be removed from the saddle shaft.
•
Remove clamping plate from saddle tube
•
Pull saddle tube off the saddle motor.
•
Unscrew the 4 screws of the saddle guide tube and
remove the tube
•
Loosen bottom fixation of the saddle motor (screw
and nut are accessible via a hole at the bottom).
•
Remove the saddle motor.
•
The new motor is assembled in reverse order.
•
Perform a saddle calibration (service menu) to adjust
the top and bottom position.
- 90 -
B
)
e
Ike CoMfort
eBike II, eBike II L, eBike II EL
2018112-069 Rev. F