Table of Contents
Advertisement
•
Follow the instructions given on the screen. Confirm
the installation if a warning for a non indentified
program is displayed.
•
Click „Finish" to start the first part of the USB driver
installation.
•
Connect the eBike with the USB cable to the PC an
switch the eBike on:
eBike is automatically recognized by WINDOWS and
the driver is loaded („Silicon Labs CP 210x").
•
Follow instructions given on the screen.
•
Remove the CD from the drive unit.
C
usB
HeCk
InterfaCe
The eBike has to be connected to the PC via USB cable and
switched on.
•
Start the WINDOWS „Device manager".
•
Double click „COM & LPT" to display all connections.
•
For CardioSoft/CS V6.71 and below:
If an USB Serial Port („Silicon Labs CP 210x USB to
UART Bridge") is assigned from COM1 up to COM4 no
change is necessary. If an USB Serial Port higher COM4
is assigned, one of the COM ports 1 to 4 has to be
deactivated to use this port number for eBike.
•
For CardioSoft/CS V6.73 and above:
If an USB Serial Port („Silicon Labs CP 210x USB to
UART Bridge") is assigned from COM1 up to COM32
no change is necessary. If an USB Serial Port higher
COM32 is assigned, one of the COM ports 1 to 32 has
to be assigned to use this port number for eBike.
•
Keep the assigned COM port in mind - this port
number has ti be used in the CardioSoft/CS settings.
Close all open windows.
C
CoM
Hange
port assIgnMent
•
Right mouse click onto „Silicon Labs CP 210x USB to
UART Bridge (COMx)"
•
Select „Settings"
•
Select Tab „Port Settings".
•
Click onto „Advanced".
•
For CardioSoft/CS V6.71 and below:
Click onto „COM Port Number" and select an unused
COM port between COM1 and COM4.
- 32 -
eBike II, eBike II L, eBike II EL
2018112-069 Rev. F
Advertisement
Table of Contents
