Addendum; Errorcodes Software Ebike; Error Code Bits Zme - GE eBike II Series Service Manual

a
ddenduM
e s
rrorCodes oftware e
Every electronic module of the eBike II ergometers has its own error codes.
If an error occurs, a hexadecimal code is displayed on the ergometer display and internally stored with date/time of first
occurence and numbers of recurrences.
The displayed hexadecimal code is a combination of single error bits, each representing a special fault condition.
e.g.: Displayed Error
Bit conversion:
Error bits set:
e ZMe
rror Code BIts
Bit Error
0 Illegal program jump
1 Wrong SW configuration
2 not used
3 LCD communication error
4 +24V out of range
5 +5V out of range
6 2,5V out of range
7 Safety state mode
8 RAM-Test error
- 134 -
B II
Ike
Source: ZME
Err.Code: 0028 (hexadecimal)
0 0 0 0
Bit 3 LCD communication error
Bit 5 +5V out of range
Reaction
Safety shut down
Safety shut down
Safety shut down
Safety shut down
Safety shut down
Safety shut down
eBike II, eBike II L, eBike II EL
0 0 1 0
0 0 0 0
Display / Info Troubleshooting
- restart eBike (OFF / ON)
- if error persists: replace ZME
Warning - perform software update
- check LCD connection
- replace LCD
- replace ZME PCB
Internal error - check power supply
- check connections:
- restart eBike (OFF / ON)
- if error persists: replace ZME
- restart eBike (OFF / ON)
- if error persists: replace ZME
- restart eBike (OFF / ON)
- if error persists: replace ZME
- restart eBike (OFF / ON)
- if error persists: replace ZME
1 0 0 0
(0028 hex)
power supply to LRE
cable ZME <-> LRE
(or ZME <-> BDE
BDE <-> LRE)
2018112-069 Rev. F