Error Code Bits Com - GE eBike II Series Service Manual

e CoM
rror Code BIts
Bit Error
0 not used
1 not used
2 not used
3 not used
4 +24V out of range
5 not used
6 not used
7 Safety state mode
8 Setup not ready
9 CAN zykl. Timeout
- 138 -
Reaction Display / Info
Warning
Module is switched off Internal error
Module is switched off Internal error
Module is switched off Internal error
eBike II, eBike II L, eBike II EL
Troubleshooting
- check mounting of COM
(DSUB connector)
- check jumper on BKE
- check power supply
- check connections:
power supply to LRE
cable LRE <-> BKE
- replace COM
- restart eBike (OFF / ON)
- check mounting of COM
(DSUB connector)
- check jumper on BKE
- if error persists: replace COM
- check mounting of COM
(DSUB connector)
- check jumper on BKE
- restart eBike (OFF / ON)
- if error persists: replace COM
- check mounting of COM
(DSUB connector)
- check jumper on BKE
- restart eBike (OFF / ON)
- if error persists: replace COM
2018112-069 Rev. F